SerVision CVG-M Przewodnik Instalacji Pobierz pdf (Strona 20)

SerVision CVG-M Installation Guide

Connecting Devices to the CVG-M 19

Figure 17: RS232/485 adapter

Note: If you connect an ADAM module to the unit, you cannot connect any RS232 PTZ controllers, a touch-

screen controller, or an IA relay board to the unit. For additional information, see Connecting a PTZ

Controller, page 14; Connecting a CCTV Monitor, page 23; Connecting Sensors and Activators Using an IA

Relay Board, page 21.

5. Connect the ADAM-4051 module to the power source as follows (see figure 18, page 20):

•

Connect the positive (+) wire of the power supply cable to the (R) +Vs connector on the module

•

Connect the negative (-) wire of the power supply cable to the (B) GND connector on the module

Note: Each of the power connectors on the module will then have two wires connected to it – one connecting

it to the power supply, and one connecting it to the power connectors of the ADAM-4520 converter.

Note: You may be able to supply power to the modules by connecting it to the 12VDC Power Out connector

on the rear panel of the unit (see Using the 12VDC Power Out Connector, page 36).

Plug into RS232/485

connector on CVG-M

RS232 connector

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 37 38

Brak uwag

SerVision CVG-M Przewodnik Instalacji Strona 20