SerVision CVG-M Informacje Techniczne Pobierz pdf (Strona 17)

SerVision Embedded Video Gateway System Guide

Getting Started 16

2. In the Connection Panel (left panel) of the MultiClient, select the Video Gateway.

3. At the bottom of the Connection Panel, click the Config button. A new browser window opens, and

automatically connects to the configuration utility login page for the Video Gateway.

Note: If you cannot connect remotely through port 10000, the login page will not appear at this point, and the

browser will display an error message instead. Change the port number in the Address field of the browser

from 10000 to the port that is set in the router's port forwarding settings (see General System Settings,

page 19), and press Enter to reload the page. The login page should then appear. For additional information,

see Opening the Configuration Manually, below.

Note: If more than one SerVision Video Gateway is connected to the internet via the same router, each of

them must use a different port. When you click Config in the MultiClient, the browser automatically connects

to port 10000. As a result, the MultiClient may initially connect you to the wrong Video Gateway unit. In this

case, you should manually correct the port number in the Address field of the browser, as explained in the

previous note.

Opening the Configuration Manually

The configuration utility can be opened manually in a browser using the IP address and port of the unit. This is

particularly useful in situations in which you cannot open the configuration utility through the MultiClient. This is

most likely to occur when you are opening the configuration utility remotely and either do not have access to the

MultiClient or cannot connect to the unit remotely through port 10000.

To open the configuration utility manually, you must know the network address (IP or hostname) of the Video

Gateway and the port allowing access to the configuration utility. The required network address depends on whether

you are accessing the configuration utility through a local connection (through the same LAN or through an

Ethernet cross cable) or a remote connection (through the internet):

 Local connection: The network address is the private IP address of the Video Gateway on the local network.

This can either be its dynamic IP, or, if it has one, its static IP. The port is 10000.

 Remote connection: The network address is the public IP or hostname of the router through which the Video

Gateway connects to the internet. The port is the port that allows access to the configuration utility via port

forwarding.

If you connect through a proxy connection, you must also know the network address and port of the proxy server.



To open the configuration utility manually:

1. Open a web browser.

2. In the Address field of the browser, enter the IP address and system port number of the Video Gateway, as

follows:

 Connection

Type

 Address

Direct (local or

remote)

http://IP:port

For example, if the Video Gateway’s IP address is 192.168.1.210 and you are

connecting on port 10000, enter http://192.168.1.210:10000, as in figure 14:

Figure 14: Address for configuring a unit with a static IP

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 202 203

Komentarze do niniejszej Instrukcji

Brak uwag

SerVision CVG-M Informacje Techniczne Strona 17

Komentarze do niniejszej Instrukcji