SerVision CVG-M Przewodnik Instalacji Pobierz pdf (Strona 31)

SerVision CVG-M Installation Guide

Connecting the CVG-M to a Power Source 30

Figure 29: No wire connector connected to Power connector

Figure 30: Wire connector connected to Power connector

In order to connect the unit to the vehicle battery, the wire connector must be connected to the Power connector on

the unit. Therefore, if your unit was supplied as a demo unit or as part of a small order, you must remove the wire

connector from the power-connector cable and connect it to the unit.



To connect the wire connector to the unit:

• Plug the wire connector into the Power connector on the rear panel of the unit, and tighten the screws to

secure it.

Connecting the Unit to an Electrical Outlet

If a standard electrical outlet is available, the unit can be connected to it. For example, if you want to configure or

test the unit indoors, you can power the unit in this way.

WARNING: Only the power supply cable that came with the unit (or with the shipment) should be used to

connect the unit to an electrical outlet. Use of a power supply other than the one provided in the

package may cause irreparable damage to the unit.

NOTE: If the unit was supplied as part of a large order, power-supply and power-connector cables were not

supplied for each individual unit. The cables that were supplied should be reused for all the units (see

The CVG-M Package, page 4).



To connect the CVG-M to a standard electrical outlet:

1. Connect the power-connector cable to the power-supply cable.

2. If a wire connector is connected to the Power connector on the unit, unscrew the screw holding it in place, and

remove it.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37 38

Brak uwag

SerVision CVG-M Przewodnik Instalacji Strona 31